Homelite Bandit St155 Manual

Homelite Bandit St155 Manual Rating: 7,4/10 9963 votes

Related Articles

  • 1 Increase the Line on a Stihl Weed Wacker
  • 2 Fill the RT110 Weed Eater
  • 3 String a Troy-Bilt TB575SS
  • 4 Install a Weed Eater Line

The SX-135, model number UT20601, is part of the Versa Tool line of outdoor power equipment manufactured by Homelite and is operated in the same manner as the model UT20818. To get the most out of the SX-135 trimmer, understanding how to mix fuel for the 2-cycle engine, the starting process and adding trimmer line are essential. A basic understanding of how to operate the trimmer will also help to avoid potential issues.

Get the best deals on homelite blower parts when you shop the largest online selection at eBay.com. Free shipping on many items. Homelite IMPERIAL Snow Blower Parts Manual Thrower SNO 524 UT35014 826 35015. FAST 'N FREE. 1x Carb Kit RB-20 For Homelite Blower ST155 ST175 ST285 ST385 HB-180 ZAMA Parts. Need to fix your ST155 (UT-20539-A) String Trimmer? Use our part lists, interactive diagrams, accessories and expert repair advice to make your repairs easy. Repair Parts Home Lawn Equipment Parts Homelite Parts Homelite Trimmer Parts Homelite ST155 (UT-20539-A) String Trimmer Parts. How to Replace the Drive Shaft on a String Trimmer.

1

Add 2.6 ounces of 50-to-1 ratio 2-cycle engine oil to a fuel container. Add 1 gallon of gasoline to the container, place the top on the container and shake to mix. Pour the mix into the fuel tank on the trimmer.

2

Remove the spark plug wire from the spark plug for safety while replacing the trimmer line. Hold the trimmer head and turn the spool counterclockwise, and then pull to remove it from the head. Pull the old line off the spool and discard.

3

Cut two lengths of .080-inch diameter trimmer line that are both 9 feet long with snips from a filler spool. Insert the end of one 9-foot length into the hole in the upper line channel on the spool. Wind the line counterclockwise onto the spool. Leave 6 inches of the line extending from the spool and secure the line in the notch on the side.

4

Insert an end of the other 9-foot length of line into the hole in the lower line channel on the spool. Wind the line counterclockwise, leaving 6 inches extended, and secure it in the notch on the opposite side of the spool.

5

Feed the lines through the holes in the trimmer head. Secure the spool in the head and pull the lines to release them from the notches.

6

Start the trimmer by placing it on the ground. Move the control switch to the 'On' position. Push the primer bulb eight times.

7

Move the choke lever to the 'Choke' position and press the trigger throttle. Pull the starter cord until the engine attempts to start but no more than six times to prevent flooding the engine. Move the choke lever to the 'Half Choke' position.

8

Pull the starter cord to start the engine and continue to press the trigger throttle. Run the engine for at least 30 seconds, release the trigger throttle and move the choke lever to the 'Run' position.

9

Keep the trimmer at full throttle while operating with the front edge of the trimmer line tilted slightly down toward the grass or weeds.

Homelite st155 oil mixture

10

Tap the bottom of the trimmer head on the ground to advance line from the head for cutting grass and weeds. Tap the head up to three times to advance line as needed.

Things You Will Need

  • 50-to-1 2-cycle engine oil
  • Fuel container
  • Gasoline
  • .080-inch diameter trimmer line
  • Snips
  • Safety glasses

Warnings

  • Always wear safety glasses when operating a string trimmer.
  • Avoid cutting grass and weeds when they are wet.
  • Use caution around trees and plants to prevent damage.

References (2)

About the Author

Keith Dooley has done work in the field of landscaping and design for more than 10 years. He has implemented his own designs, as well as pulled from techniques learned through studies, creating many landscapes for others to enjoy.He has also maintained lawns, athletic fields, town parks, large gardens and game fields.

OBS Classic (Deprecated)OBS Classic is no longer supported or maintained; please use OBS Studio for new projects.The original Open Broadcaster Software bundle comes with both 32-bit and 64-bit versions and is available only for Windows.This program and its source code are freely available for all to use and change under the GNU General Public License v2.0 (or greater), which you agree to when using this program or its source code.Note: Major development has been moved to OBS StudioIf you wish to contribute. Baselight software free download.

Photo Credits

  • Siri Stafford/Digital Vision/Getty Images